All: Disable All Nmea Messages - ashtech GG Surveyor Reference Manual

Position Information
RAIM Information
Residual Information
Satellite Information
Time and Date
Track, Speed

ALL: Disable All NMEA Messages

$PASHS,NME,ALL,x,OFF
Disable ALL NMEA message types on port x, where x is the output port.
Examples: Turn off all NMEA messages for Port A.
AIM: Receiver Autonomous Integrity Monitor Message
$PASHS,NME,AIM,x,s
Enable/disable RAIM message on port x, where x is the output port, and s is ON or
OFF. This message is not output unless a position is computed.
Example: Enable RAIM message on port B.
132
Table 6.43: NMEA Data Message Commands (continued)
Command
$PASHS,NME,GGA
$PASHS,NME,GLL
$PASHS,NME,GXP
$PASHS,NME,POS
$PASHS,NME,RMC
$PASHS,NME,AIM
$PASHS,NME,RRE
$PASHS,NME,GRS
$PASHS,NME,GST
$PASHS,NME,GSA
$PASHS,NME,GSN
$PASHS,NME,SAT
$PASHS,NME,ZDA
$PASHS,NME,VTG
$PASHS,NME,ALL,A,OFF <Enter>
$PASHS,NME,AIM,B,ON<Enter>
Description
Enable/disable GPS position response message
Enable/disable lat/lon message
Enable/disable position computation with time
of fix information
Enable/disable position message
Enable/disable declination message
Enable/disable RAIM message
Enable/disable satellite residual and position
error
Enable/disable satellite range residual
Enable/disable position error message
Enable/disable satellites used message
Enable/disable signal strength/satellite number 143
Enable/disable satellite status message
Enable/disable time and date message
Enable/disable velocity/course message
GG Surveyor GPS+GLONASS Reference Manual
Page
134
137
147
162
132
166
138
134
174
172