Warning Messages; Table 4.9: Front Panel Warnings - ashtech Z-Surveyor Operation And Reference Manual

If some warning were generated before changing the language, they will remain in the original
language even after the language is changed. Only new warnings will be displayed in the selected
language.
• Beep
Allows you to turn the beeper on or off (default is on).
• Save
Saves the current values of the user parameters to the battery backed-up
memory so they can be restored when powering the receiver back on.

Warning Messages

The receiver checks a number of conditions that are of interest to the user. Whenever
one of these conditions is true, the display is interrupted to show a message, called a
warning, stating what the condition is. The warning message is flashing to distinguish
it from a regular menu and the beep will come on for 1 second every 10 seconds
(unless disabled).
When the user has acknowledged the warning (by pressing either key), the display
returns to whatever it was displaying before being interrupted, and the beep stops.
At times, the receiver can generate several warnings at once. In this case, the receiver
will display the highest priority warning until it is acknowledged. The receiver will
then display the remaining warnings in sequence, according to their priority.
Table 4.9 contains the possible warnings the receiver may issue.
Warning
Int. Battery Error :
SMBus
Int. Battery Error :
Access
Battery Conditioning
Required
Low Int. Battery : < 10
min
Operations

Table 4.9: Front Panel Warnings

Definition
The SMBus Remove battery and reinsert it. If problem
controller (for the persists, insert a different battery. If problem still
internal battery persists, contact customer support.
communication) is
not working
Can't access the Remove battery and reinsert it. If problem
internal battery persists, insert a different battery. If problem still
persists, contact customer support.
Internal battery Perform battery reconditioning (depends on the
efficiency is down, It battery, but typically means full charge, full
requires a discharge and full charge again)
conditioning cycle.
Internal battery Replace battery with a charged one.
remaining life is < 10
min, the battery needs
to be changed
Action
55