Sti: Set Station Identification - ashtech GG Surveyor Reference Manual

STI: Set Station Identification

$PASHS,RTC,STI,d
Set user station identification (user STID) to any value between 0000 and 1023. In
RTCM differential mode, corrections will not be applied if the station ID between
base and rover are different, unless rover is set to zero. If user STID of rover station is
set to zero, the GG Surveyor will attempt to use the differential corrections it receives,
regardless of STID of base station. Default is 0000.
Example: Set site identification to 0001
TYP: Enable Type of Message
$PASHS,RTC,TYP,x,s
Enables the type of message to be sent by the base station and the period at which it
will be sent, where x is the type and s is the period. Used only in BASE mode. Table
6.94 lists the type of messages available and the period range setting.
Type
1
2
3
6
9
16
18
19
22
31
32
6G
34
36
Command/Response Formats
$PASHS,RTC,STI,0001<Enter>
Table 6.94: Base Station Message Types and Period Ranges
0-99 seconds, where 0 is disabled and 99 is generated continuously
Delta differential GPS corrections
0-99 minutes, where 0 is disabled and 99 is generated continuously
ON or OFF Default = OFF
0-99 seconds, where 0 is disabled and 99 is generated continuously
0-99 minutes, where 0 is disabled and 99 is generated continuously
0-99 seconds, where 0 is disabled and 99 is generated continuously
0-99 seconds, where 0 is disabled and 99 is generated continuously
0-99 minutes, where 0 is disabled and 99 is generated continuously
0-99 seconds, where 0 is disabled and 99 is generated continuously
0-99 minutes, where 0 is disabled and 99 is generated continuously
ON or OFF Default is OFF
0-99 seconds, where 0 is disabled and 99 is generated continuously
0-99 minutes, where 0 is disabled and 99 is generated continuously
Range
183