Sag: Enable/Disable Glonass Satellite Almanac Message - ashtech GG Surveyor Reference Manual

Example:
where Table 6.36 outlines the response parameters:
Field
RCI:020.00
MSV:3
ELM:05
SIT:????
RAW:
PRTA
PRTB
PRTC
OFF/ON

SAG: Enable/Disable GLONASS Satellite Almanac Message

$PASHS,RAW,SAG,x,s
Enable/disable GLONASS almanac data (SAG) messages on port x, where x is the
output port, and s is ON or OFF.
Example: Disable SAG message on port A
Almanac data for all satellites is output once every hour, with one satellite output at each recording
interval (RCI).
Command/Response Formats
$PASHQ,RAW
Typical Response Message
RCI:020.00 MSV:3 ELM:05
RAW: MBN PBN SNV SAL MCA
PRTA: OFF OFF OFF OFF OFF
PRTB: OFF OFF OFF OFF OFF
Table 6.36: $PASHQ,RAW Response Parameters
This is the output interval of the data in seconds. Default is once every 20
seconds.
Minimum number of satellites for the data to be output. Default is 3.
Data elevation mask. Elevation below which data from that satellite will
not be output.
Four-character site name.
Raw data types: MBN, PBN, SNV, SAL, MCA, SNG, SAG.
Communication Ports A, B, and C.
OFF indicates that the RAW data message is not sent to the port.
ON indicates the RAW data message is sent to the communication port.
$PASHS,RAW,SAG,A,OFF<Enter>
SIT:????
SNG SAG
OFF OFF
OFF OFF
Description
121