Spd: Set Rtcm Bit Rate - ashtech GG Surveyor Reference Manual

SPD: Set RTCM Bit Rate

$PASHS,RTC,SPD,d
Set the number of bits per second that are being generated to the serial port of the base
station, where d is the code for the output rate in bits per second. Default is 300 bits
per second. Used only in BASE mode. Table 6.92 lists the bit rate codes.
Code
Rate
Example: Set bit rate to 110 bits/sec
STH: Health of Reference Station
$PASHS,RTC,STH,d
Set the health of the reference station, where d is any value between 0 and 7. Used
only in BASE mode. Default is 0. Table 6.93 lists the codes for the station health.
Example: Set health to "Reference station not working"
182
Table 6.92: Bit Rate Codes
0 1 2
25 50 100
$PASHS,RTC,SPD,3<Enter>
Table 6.93: Reference Station Health Codes
Code
7 Reference station not working.
6 Reference station transmission not monitored.
5 Specified by service provider.
4 Specified by service provider.
3 Specified by service provider.
2 Specified by service provider.
1 Specified by service provider
0 Specified by service provider.
$PASHS,RTC,STH,7<Enter>
3 4 5
110 150 200
Health Indication
GG Surveyor GPS+GLONASS Reference Manual
6 7 8
250 300 1500
9
Burst
Mode