TJ
TRANSFER CASE-NV231 (Continued)
Fig. 39 Output Shaft Rear Bearing Installation
1 - HANDLE C-4171
2 - OUTPUT SHAFT INNER BEARING
3 - INSTALLER 5066
Fig. 40 Output Shaft Rear Bearing Installation Depth
1 - BEARING (SEATED) AT LOWER EDGE OF CHAMFER
2 - CHAMFER
(9) Using Remover C-4210 and Handle C-4171,
drive input shaft bearing from inside the annulus
gear opening in the case (Fig. 41).
(10) Install locating ring on new bearing.
(11) Position case so forward end is facing upward.
2001 JEEP WRANGLER
1 - SPECIAL TOOL C-4171
2 - SPECIAL TOOL C-4210
(12) Using Remover C-4210 and Handle C-4171,
drive input shaft bearing into case. The bearing
locating ring must be fully seated against case sur-
face (Fig. 42).
1 - SNAP-RING
2 - INPUT SHAFT BEARING
TRANSFER CASE-NV231
Fig. 41 Input Shaft Bearing Removal
Fig. 42 Seating Input Shaft Bearing
21s - 129