Thrust Washer/Spacer/Snap-Ring Dimensions; Pressure Test - Jeep Wrangler 2001 Service Manual

21s - 106 AUTOMATIC - 32RH
AUTOMATIC - 32RH (Continued)
COMPONENT
Front clutch thrust washer (reaction shaft support hub)
Rear clutch thrust washer (clutch retainer)
Output shaft thrust plate (output shaft pilot hub)
Output shaft thrust washer (rear clutch hub)
Rear clutch pack snap-ring
Planetary geartrain snap-ring
(at front of output shaft)
ITEM
Line pressure (at
accumulator)
Front servo
Rear servo
Governor
2001 JEEP WRANGLER

THRUST WASHER/SPACER/SNAP-RING DIMENSIONS

PRESSURE TEST

RANGE
Closed throttle
Third gear only
1 range
R range
D range closed throttle
METRIC
1.55 mm
1.55 mm
1.5-1.6mm
1.3-1.4 mm
1.7-1.8 mm
2.1-2.2 mm
1.5 mm
1.7 mm
1.9 mm
2.5 mm
1.0-1.1 mm
1.6-1.7 mm
2.1-2.2 mm
PRESSURE
372-414 kPa (54-60 psi).
No more than 21 kPa (3 psi) lower than line pressure.
No more than 21 kPa (3 psi) lower than line pressure.
1103 kPa (160 psi) at idle, builds to 1862 kPa (270 psi)
at 1600 rpm.
Pressure should respond smoothly to changes in mph
and return to 0-7 kPa (0-1.5 psi) when stopped with
transmission in D, 1, 2. Pressure above 7 kPa (1.5 psi)
at stand still will prevent transmission from
downshifting.
TJ
INCH
0.061 in.
0.061 in.
0.060-0.063 in.
0.052-0.054 in.
0.068-0.070 in.
0.083-0.086 in.
0.060 in.
0.068 in.
0.076 in.
0.098 in.
0.040-0.044 in.
0.062-0.066 in.
0.082-0.086 in.