Table of Contents
Advertisement
TJ
MANUAL-NV3550 (Continued)
Fig. 127 Propeller Shaft
1 - REFERENCE MARKS
(24) Install and tighten propeller shaft U-joint
clamp bolts to 19 N·m (170 in. lbs.).
SPECIFICATIONS
TRANSMISSION - NV3550
DESCRIPTION
Clutch Housing Bolts
Crossmember To Frame Bolts
Crossmember To Insulator
Nuts
Drain/Fill Plug
Front To Rear Housing Bolts
Front Bearing Retainer Bolts
Idler Shaft Bolts
Rear Bearing Retainer Bolts
Shift Tower Bolts
Slave Cylinder Nuts
Transfer Case Nuts
U-Joint Clamp Bolts
2001 JEEP WRANGLER
(25) Align marks on front propeller shaft, axle and
transfer case yokes, if equipped.
(26) Install and tighten propeller shaft U-joint
clamp bolts to 19 N·m (170 in. lbs.).
(27) Install slave cylinder in clutch housing.
(28) Install skid plate, if equipped and tighten
bolts to 42 N·m (31 ft. lbs.). Tighten stud nuts to 17
N·m (150 in. lbs.).
(29) Fill
equipped, with recommended lubricants. Refer to the
Lubricant Recommendation sections of the appropri-
ate component for correct fluid.
(30) Lower vehicle.
(31) Install nuts on two M6X1.0 bolts and thread
the bolts into the threaded holes at the base of the
shift lever.
(32) Tighten the nuts equally until the shift lever
will slide over the shift tower stub shaft.
(33) Install the floor console and shift boot.
TORQUE SPECIFICATIONS
N·m
54-61
61-75
54-61
9-27
30-35
7-10
19-25
30-35
7-10
23
47
19
MANUAL-NV3550
transmission
and
Ft. Lbs.
40-45
44-55
40-45
14-20
22-26
5-7
14-18
22-26
5-7
17
35
14
21s - 71
transfer
case
if
In. Lbs.
-
-
-
-
-
62-88
-
-
62-88
-
-
-
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
