Accumulator; Bands; Adjustment - Front Band; Accumulator Components - Jeep Wrangler 2001 Service Manual

TJ
AUTOMATIC - 32RH (Continued)

DESCRIPTION

Bolt/nut, crossmember
Bolt, driveplate to
crankshaft
Plug, front band reaction
Locknut, front band adj.
Switch, park/neutral
Bolt, fluid pan
Bolt, oil pump
Bolt, overrunning clutch
cam
Plug, pressure test port
Bolt, reaction shaft
support
Locknut, rear band
Bolt. speedometer adapter
Screw, fluid filter
Bolt, valve body to case

ACCUMULATOR

INSPECTION

Inspect the accumulator piston and seal rings (Fig.
61). Replace the seal rings if worn or cut. Replace the
piston if chipped or cracked.
Check condition of the accumulator inner and
outer springs (Fig. 61). Replace the springs if the
coils are cracked, distorted or collapsed.
Fig. 61 Accumulator Components
1 - INNER SPRING
2 - ACCUMULATOR PISTON
3 - OUTER SPRING
4 - SEAL RINGS
2001 JEEP WRANGLER
TORQUE SPECIFICATIONS
N·m
31
68
75
34
34
17
20
17
14
20
41
11
4
12

BANDS

ADJUSTMENT - FRONT BAND

The front (kickdown) band adjusting screw is
located on the left side of the transmission case
above the manual valve and throttle valve levers.
(1) Raise vehicle.
(2) Loosen band adjusting screw locknut (Fig. 62).
Then back locknut off 3-5 turns. Be sure adjusting
screw turns freely in case. Apply lubricant to screw
threads if necessary.
(3) Tighten band adjusting screw to 8 N·m (72 in.
lbs.)
C-3380-A, a 3-in. extension and the appropriate
Torx™ socket.
CAUTION: If Adapter C-3705 is needed to reach the
adjusting screw, tighten the screw to only 5 N·m
(47-50 in. lbs.) torque.
(4) Back off front band adjusting screw 2-1/4
turns.
(5) Hold adjuster screw in position and tighten
locknut to 41 N·m (30 ft. lbs.) torque.
(6) Lower vehicle.
AUTOMATIC - 32RH
Ft. Lbs.
23
50
55
25
25
13
15
13
10
15
30
8
-
-
torque with Inch Pound
21s - 107
In. Lbs.
-
-
-
-
-
-
-
-
-
-
-
-
35
100
Torque Wrench