Remove Input Gear Pilot Bearing; Install Input Gear Pilot Bearing; Install Front Bearing Retainer Seal - Jeep Wrangler 2001 Service Manual

21s - 130 TRANSFER CASE-NV231
TRANSFER CASE-NV231 (Continued)
(13) Remove input gear pilot bearing by inserting
a suitably sized drift into the splined end of the input
gear and driving the bearing out with the drift and a
hammer (Fig. 43).
(14) Install new pilot bearing with Installer 5065
and Handle C-4171 (Fig. 44).
Fig. 43 Remove Input Gear Pilot Bearing
1 - DRIFT
2 - INPUT GEAR
(15) Remove front bearing retainer seal with suit-
able pry tool.
(16) Install new front bearing retainer seal with
Installer 7884 (Fig. 45).
(17) Remove seal from oil pump housing with a
suitable pry tool
(18) Install new seal in oil pump housing with
Installer 7888 (Fig. 46).
(19) Remove rear retainer bearing with Installer
8128 and Handle C-4171.
(20) Install rear bearing in retainer with Handle
C-4171 and Installer 5064 (Fig. 47).
2001 JEEP WRANGLER
1 - SPECIAL TOOL C-4171
2 - SPECIAL TOOL 5065
3 - INPUT GEAR
Fig. 45 Install Front Bearing Retainer Seal
1 - FRONT BEARING RETAINER
2 - SPECIAL TOOL 7884
Fig. 44 Install Input Gear Pilot Bearing
TJ