Cluster Lens; Cluster Hood And Mask; Cluster Housing Rear Cover; Trip Odometer Reset Knob Boot - Jeep Wrangler 2001 Service Manual

TJ
INSTRUMENT CLUSTER (Continued)
Fig. 3 Cluster Bulb Locations
1 - CLUSTER INCANDESCENT BULBS
(4) Pull the bulb and bulb holder unit straight
back to remove it from the bulb mounting hole in the
cluster electronic circuit board.

CLUSTER LENS

(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument cluster from the instru-
ment panel. (Refer to 8 - ELECTRICAL/INSTRU-
MENT CLUSTER - REMOVAL).
(3) Work around the perimeter of the cluster lens
and disengage each of the latches that secure the
lens to the cluster housing (Fig. 4).
Fig. 4 Instrument Cluster Components

1 - CLUSTER HOUSING REAR COVER

2 - CLUSTER HOUSING
3 - CLUSTER HOOD & MASK
4 - CLUSTER LENS
5 - RESET KNOB BOOT
2001 JEEP WRANGLER
(4) Gently pull the cluster lens away from the clus-
ter housing.

TRIP ODOMETER RESET KNOB BOOT

(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument cluster from the instru-
ment panel. (Refer to 8 - ELECTRICAL/INSTRU-
MENT CLUSTER - REMOVAL).
(3) Remove the cluster lens from the cluster hous-
ing. Refer to CLUSTER LENS for the proper cluster
lens removal procedures.
(4) Remove the odometer reset knob boot by pull-
ing it out from the face of the cluster lens (Fig. 4).

CLUSTER HOOD AND MASK

(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument cluster from the instru-
ment panel. (Refer to 8 - ELECTRICAL/INSTRU-
MENT CLUSTER - REMOVAL).
(3) Remove the cluster lens from the cluster hous-
ing. Refer to CLUSTER LENS for the proper cluster
lens removal procedures.
(4) Work around the perimeter of the cluster hood
and mask unit and disengage each of the latches that
secure the cluster hood and mask unit to the cluster
housing (Fig. 4).
(5) Gently pull the cluster hood and mask unit
away from the cluster housing.
CLUSTER HOUSING REAR COVER
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument cluster from the instru-
ment panel. (Refer to 8 - ELECTRICAL/INSTRU-
MENT CLUSTER - REMOVAL).
(3) Remove the two screws that secure the rear
cover to the cluster housing.
(4) Work around the perimeter of the cluster hous-
ing rear cover and disengage each of the latches that
secure the cover to the outside of the cluster housing
(Fig. 4).
(5) Disengage the one inboard latch located near
the lower edge of the rear cover just right of center
that secures the rear cover to the cluster housing.
(6) Gently pull the cluster housing rear cover away
from the back of the cluster housing.
INSTRUMENT CLUSTER 8Js - 13