Antenna Body & Cable; Audio; Amplified Subwoofer Description - Jeep Wrangler 2001 Service Manual

8As - 2

AUDIO

AMPLIFIED SUBWOOFER (Continued)
inoperative speaker location(s)
receiver wire harness connectors and to the amplified
subwoofer for continuity. In each case, there should
be continuity. If not OK, repair the shorted speaker
feed (+) and/or return (–) circuit(s) to the speaker as
required. If OK, replace the amplified subwoofer.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the center console (Refer to 23 -
BODY/INTERIOR/CENTER CONSOLE - REMOV-
AL).
(3) Disconnect wire harness retainer.
(4) Disconnect wire harness connector.
(5) Remove the mounting screws from the side of
the console.
(6) Open console lid and remove the retaining fas-
teners from the console.
(7) Remove amplified subwoofer from console.
INSTALLATION
(1) Install amplified subwoofer to console.
(2) Install retaining fasteners to the top of the con-
sole.
(3) Install the mounting screws to the side of the
console.
(4) Connect wire harness connector and retainer.
(5) Install the center console (Refer to 23 - BODY/
INTERIOR/CENTER CONSOLE - INSTALLATION).
(6) Connect the battery negative cable.
ANTENNA BODY & CABLE
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, (REFER TO
BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL
COMPONENT DIAGNOSIS OR SERVICE. FAILURE
TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the glove box from the instrument
panel. (Refer to 23 - BODY/INSTRUMENT PANEL/
GLOVE BOX - REMOVAL).
(3) Reach through the instrument panel glove box
opening to unplug the antenna coaxial cable connec-
tor. Unplug the connector by pulling it apart while
twisting the metal connector halves. Do not pull on
the cable.
2001 JEEP WRANGLER
from the radio
ELECTRICAL/RESTRAINTS)
(4) Unscrew the antenna mast from the antenna
body base on the right outer cowl side panel (Fig. 1).
Fig. 1 Antenna Remove/Install
1 - RIGHT COWL SIDE PANEL
2 - BASE & CABLE
3 - GROMMET
4 - SCREW
5 - COVER
6 - MAST
(5) Using a trim stick or another suitable wide
flat-bladed tool, gently pry the edge of the antenna
base trim cover to unsnap it from the antenna body
base.
(6) Remove the three screws that secure the
antenna body base to the right outer cowl side panel.
(7) From inside the passenger compartment, push
the coaxial cable grommet on the antenna body half
of the coaxial cable out through the hole in the right
inner cowl side panel.
(8) From the outside of the vehicle, pull the
antenna body base and cable assembly out through
the hole in the right outer cowl side panel.
INSTALLATION
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, (REFER TO
BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL
COMPONENT DIAGNOSIS OR SERVICE. FAILURE
TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
ELECTRICAL/RESTRAINTS)
TJ