Front Bearing; Front Bearing Retainer; Speedometer Drive Gear; Adapter/Extension Housing–Typical - Jeep Wrangler 2001 Service Manual

21s - 20 MANUAL-AX5
MANUAL-AX5 (Continued)
(4) Install new front bearing snap rings (Fig. 67).
Fig. 67 Front Bearing
1 - FRONT BEARING SNAP RINGS
(5) Install front bearing retainer gasket to front
bearing retainer.
(6) Install front bearing retainer (Fig. 68) and
tighten bolts to 17 N·m (12 ft. lbs.).
Fig. 68 Front Bearing Retainer

1 - FRONT BEARING RETAINER

(7) On 4x2 transmissions, install speedometer
drive gear locating snap-ring (Fig. 69). Install speed-
ometer gear lock ball in output shaft and install
speedometer gear onto output shaft. Install speedom-
eter gear retaining snap-ring onto output shaft.
2001 JEEP WRANGLER
1 - SNAP RING
2 - LOCK BALL
3 - SNAP RING
4 - OUTPUT SHAFT GROOVES
5 - SPEEDOMETER GEAR
(8) Apply a 1/8 to 3/16 inch wide bead of Threeb-
ond Liquid Gasket TB1281 or equivalent, to sealing
surface of adapter/extension housing. Keep sealer
bead to inside of bolt holes.
(9) Install adapter or extension housing on inter-
mediate plate (Fig. 70). Tighten housing bolts to 34
N·m (25 ft. lbs.).
(10) Position shift arm in shifter tower opening of
adapter or extension housing (Fig. 71). Verify shifter
arm is engaged into the shift rails.
Fig. 70 Adapter/Extension Housing–Typical
1 - ADAPTER HOUSING
2 - INTERMEDIATE PLATE
Fig. 69 Speedometer Drive Gear
TJ