Rear Support; Overrunning Clutch Cam Bolt Locations; Rear Band And Link; Front Band Reaction Pin Access Plug - Jeep Wrangler 2001 Service Manual

TJ
AUTOMATIC - 30RH (Continued)
Fig. 15 Rear Support
1 - OIL PAN FACE
2 - TRANSMISSION HOUSING

3 - REAR SUPPORT

Fig. 16 Overrunning Clutch Cam Bolt Locations
1 - OVERRUNNING CLUTCH CAM BOLTS
(31) Using snap-ring plier, pull rear band anchor
pin (located on the servo side of the rear support)
from transmission case.
(32) Remove rear band and link from transmission
(Fig. 17).
(33) Separate link from rear band (Fig. 18).
(34) If necessary remove front and rear band servo
levers. All transmission components can be serviced
without removing the levers.
(a) Using a 1/4 inch drive extension remove
front band reaction pin access plug (Fig. 19).
(b) Remove front band reaction pin with pencil
magnet. Pin is accessible from converter housing
side of case (Fig. 20).
2001 JEEP WRANGLER
1 - LINK
2 - REAR BAND
1 - NOTCHED SIDE OF LINK GOES TOWARD BAND
(c) Remove front band lever (Fig. 21).
(d) Using snap-ring plier, pull rear band lever
pivot from transmission case (Fig. 22).
(e) Separate rear band servo lever from trans-
mission.
Fig. 19 Front Band Reaction Pin Access Plug
1 - 1/4'' DRIVE EXTENSION

2 - FRONT BAND REACTION PIN ACCESS PLUG

(35) Compress front servo rod guide about 1/8 in.
with large C-clamp and Tool C-4470, or Spring Com-
pressor Tool C-3422-B (Fig. 23).
(36) Remove front servo rod guide snap-ring (Fig.
23). Exercise caution when removing snap-ring.
Servo bore can be scratched or nicked if care is
not exercised.
AUTOMATIC - 30RH
Fig. 17 Rear Band and Link
Fig. 18 Rear Band and Link
21s - 81