Output Shaft Rear Bearing Retaining Ring; Rear Retainer Removal; Oil Pump Removal; Pick-Up Tube O-Ring Location - Jeep Wrangler 2001 Service Manual

21s - 120 TRANSFER CASE-NV231
TRANSFER CASE-NV231 (Continued)
Fig. 3 Output Shaft Rear Bearing Retaining Ring
1 - SNAP-RING PLIERS
2 - REAR BEARING I.D. RETAINING RING
(9) Tap rear retainer with rawhide or rubber mal-
let to loosen sealer bead.
(10) Remove rear retainer from rear case half (Fig.
4).
Fig. 4 Rear Retainer Removal
1 - MAINSHAFT
2 - REAR RETAINER
(11) Remove snap-ring holding oil pump in position
on output shaft.
2001 JEEP WRANGLER
(12) Disengage oil pickup tube from oil pump and
remove oil pump assembly. Remove oil pump by tilt-
ing the edge of the oil pump from under the edge of
the rear case half and sliding the pump (Fig. 5).
1 - OIL PUMP
(13) Remove pick-up tube o-ring from oil pump
(Fig. 6), if necessary. Do not disassemble the oil
pump, it is not serviceable.
1 - OIL PUMP
2 - O-RING
Fig. 5 Oil Pump Removal
Fig. 6 Pick-up Tube O-ring Location
TJ