Front/Rear Clutch; Assembling Front And Rear Clutch Units; Output Shaft Thrust Plate - Jeep Wrangler 2001 Service Manual

21s - 100 AUTOMATIC - 32RH
AUTOMATIC - 32RH (Continued)
Fig. 44 Governor Body/Park Gear Retaining
Snap-Rings And Thrust Washer Position
1 - OUTPUT SHAFT
2 - REAR ANNULUS GEAR
3 - FEELER GAUGE

FRONT/REAR CLUTCH

(1) Install output shaft thrust plate on shaft hub
(Fig. 45). Use petroleum jelly to hold thrust plate in
place.
(2) Check input shaft seal rings. Verify that diago-
nal-cut ends of teflon seal ring are properly joined
and ends of plastic ring are correctly positioned. Also
be sure rings are installed in sequence shown.
(3) Check rear clutch thrust washer. Use addi-
tional petroleum jelly to hold washer in place if nec-
essary.
(4) Align clutch discs in front clutch and install
front clutch on rear clutch (Fig. 46). Rotate front
clutch retainer back and forth until completely
seated on rear clutch.
(5) Coat output shaft thrust washer with petro-
leum jelly. Then install washer in rear clutch hub
(Fig. 47). Use enough petroleum jelly to hold washer
in place. Be sure grooved side of washer faces
rearward (toward output shaft) as shown. Also
note that washer only fits one way in clutch
hub.
(6) Align drive teeth on rear clutch discs with
small screwdriver (Fig. 48). This will make installa-
tion on front planetary easier.
2001 JEEP WRANGLER
1 - OUTPUT SHAFT HUB

2 - OUTPUT SHAFT THRUST PLATE

Fig. 46 Assembling Front And Rear Clutch Units
1 - TURN FRONT CLUTCH BACK & FORTH UNTIL SEATED
2 - REAR CLUTCH ASSEMBLY
Fig. 45 Output Shaft Thrust Plate
TJ