Lever And Bushing Assembly; Shaft In Lever Opening; Shift Socket; Roll Pin Identification - Jeep Wrangler 2001 Service Manual

TJ
MANUAL-NV3550 (Continued)
Fig. 105 LEVER AND BUSHING ASSENBLY
1 - SHIFT SHAFT
2 - SHAFT LEVER AND BUSHING
3 - 3–4 FORK
Fig. 106 SHAFT IN LEVER OPENING
1 - SHIFT SHAFT
CAUTION: Positioning of the shift shaft detent
notch is important. Both of the shaft roll pins can
be installed even when the shaft is 180° off. If this
occurs, the transmission will have to be disassem-
bled again to correct shaft alignment.
(9) Select correct new roll pin for shift shaft lever
(Fig. 108). Shaft lever roll pin is approximately 22
mm (7/8 in.) long. Shift socket roll pin is approxi-
mately 33 mm (1-1/4 in.) long.
(10) Align roll pin holes in shift shaft, lever and
bushing. Then start roll pin into shaft lever by hand
(Fig. 109).
2001 JEEP WRANGLER

1 - SHIFT SOCKET

2 - SHIFT SHAFT
1 - SHAFT LEVER ROLL PIN
2 - SHIFT SOCKET ROLL PIN
1 - SHAFT LEVER ROLL PIN
2 - LEVER AND BUSHING
MANUAL-NV3550
Fig. 107 SHIFT SOCKET
Fig. 108 ROLL PIN IDENTIFICATION
Fig. 109 ROLL PIN IN SHIFT SHAFT
21s - 65