Gear Shift Cable; Compressing Front Clutch Piston Spring; Front Clutch Piston Installation; Clutch Piston Spring Installation - Jeep Wrangler 2001 Service Manual

TJ
FRONT CLUTCH (Continued)
Fig. 68 Compressing Front Clutch Piston Spring
1 - FRONT CLUTCH SPRING
2 - COMPRESSOR TOOL C-3575-A
3 - RETAINER SNAP-RING
4 - SPRING RETAINER
(5) Position spring in clutch piston (Fig. 70).
(6) Position spring retainer on top of piston spring.
Make sure retainer is properly installed (Fig. 67).
Fig. 69 Front Clutch Piston Installation
1 - CLUTCH PISTON
2 - FRONT CLUTCH RETAINER
(7) Compress piston spring and retainer with Com-
pressor Tool C-3575-A (Fig. 68). Then install new
snap ring to secure spring retainer and spring.
(8) Install clutch plates and discs. Install steel
plate then disc until all plates and discs are
installed.
(9) Install pressure plate and waved snap-ring.
2001 JEEP WRANGLER
1 - RETAINER
2 - CLUTCH SPRING
3 - PISTON
Clearance should be 1.70 to 3.40 mm (0.067 to
0.134 in.). If clearance is incorrect, clutch discs,
plates, pressure plates and snap ring may have to be
changed.

GEAR SHIFT CABLE

REMOVAL

(1) Shift transmission into PARK.
(2) Remove shift lever bezel and necessary console
parts for access to shift lever assembly. (Refer to 23 -
BODY/INTERIOR/FLOOR CONSOLE - REMOVAL)
(3) Disconnect cable at shift lever and feed cable
through dash panel opening to underside of vehicle.
(4) Raise vehicle.
(5) Disengage cable eyelet at transmission shift
lever and pull cable adjuster out of mounting
bracket. Then remove old cable from vehicle.
INSTALLATION
(1) Route cable through hole in dash panel. Fully
seat cable grommet into dash panel.
(2) Place the auto transmission manual shift con-
trol lever in "PARK" detent (rearmost) position and
rotate prop shaft to ensure transmission is in PARK.
(3) Connect shift cable to shifter mechanism by
snapping cable retaining ears into shifter bracket
and press cable end fitting onto lever ball stud.
(4) Place the floor shifter lever in PARK position.
Ensure that the pawl is seated within the confines of
the adjustment gauge clip.
(5) Snap the cable into the transmission bracket so
the retaining ears are engaged and connect cable end
fitting onto the manual control lever ball stud.
(6) Lock shift cable into position by pushing
upward on the adjusting lock button.
(7) Remove and discard the shift cable adjustment
gauge clip from the park gate of the shifter.
AUTOMATIC - 32RH
Fig. 70 Clutch Piston Spring Installation
21s - 113