Shift/Fork Shafts And Reverse Idler Segment; Reverse Blocker; Geartrain And Shift Component; Shift Socket Roll Pin - Jeep Wrangler 2001 Service Manual

TJ
MANUAL-NV3550 (Continued)
(15) Remove screw from reverse blocker and
remove blocker (Fig. 17) from case.
Fig. 17 REVERSE BLOCKER

1 - REVERSE BLOCKER

2 - SHIFTER SHAFT BUSHING
3 - VENT
(16) Note position of input shaft, shift shaft and
forks, and geartrain components in housing (Fig. 18).
SHIFT/FORK SHAFTS AND REVERSE IDLER
SEGMENT
(1) Unseat the roll pin that secures the shift
socket to the shift shaft with Remover 6858 as fol-
lows:
(a) Position remover on the shift shaft. Center
the tool over the roll pin and verify that the tool
legs are firmly seated on the shift socket (Fig. 19).
(b) Tilt the socket toward the side of the case.
This positions the roll pin at a slight angle to avoid
trapping the pin between the gear teeth.
(c) Tighten the tool to press the roll pin down-
ward and out of the shift socket (Fig. 19).
NOTE: Press the roll pin just enough to clear the
shift shaft. Be careful not to push the pin into the
geartrain.
2001 JEEP WRANGLER
Fig. 18 GEARTRAIN AND SHIFT COMPONENT
1 - SHIFT SHAFT
2 - BUSHING
3 - REAR HOUSING
4 - REVERSE IDLER AND SUPPORT
5 - OUTPUT SHAFT AND GEARS
6 - COUNTERSHAFT
7 - 1-2 FORK
8 - INPUT SHAFT
9 - 3-4 FORK
1 - SPECIAL TOOL 6858
2 - SHIFT SOCKET
MANUAL-NV3550
Fig. 19 SHIFT SOCKET ROLL PIN
21s - 39