Radio; Center Bezel Remove/Install; Radio Remove/Install - Jeep Wrangler 2001 Service Manual

TJ
ANTENNA BODY & CABLE (Continued)
(1) From outside the vehicle, feed the antenna
cable and base assembly through the outer cowl side
panel.
(2) From inside the passenger compartment, pull
the cable and grommet into the hole in the inside
cowl side panel until the grommet is seated.
(3) Install the three screws retaining the antenna
body base to right outer cowl side panel. Tighten the
screws to 3.3 N·m (30 in. lbs.).
(4) Screw the antenna mast to the antenna body
base.
(5) Reach through the glove box opening and
secure the antenna coaxial cable the radio antenna
port.
(6) Install the glove box to the instrument panel
(Refer to 23 - BODY/INSTRUMENT PANEL/GLOVE
BOX - INSTALLATION).
(7) Connect the battery negative cable.

RADIO

REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, (REFER TO
BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL
COMPONENT DIAGNOSIS OR SERVICE. FAILURE
TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the instrument panel top cover from
the instrument panel. (Refer to 23 - BODY/INSTRU-
MENT PANEL/INSTRUMENT PANEL TOP COVER
- REMOVAL).
(3) Remove the ash receiver from the ash receiver
housing in the lower instrument panel center bezel.
(4) Remove the one screw located in the back of
the ash receiver housing that secures the center
bezel to the lower instrument panel (Fig. 2).
(5) Remove the two screws that secure the center
bezel to the top of the instrument panel.
(6) Using a trim stick or another suitable wide
flat-bladed tool, gently pry the lower edge of the cen-
ter bezel away from the instrument panel.
(7) Lift the lower edge of the center bezel upwards
to release the four snap clip retainers that secure it
to the instrument panel.
(8) Remove the center bezel from the instrument
panel.
(9) Remove the two screws that secure the radio to
the instrument panel (Fig. 3).
2001 JEEP WRANGLER
ELECTRICAL/RESTRAINTS)
Fig. 2 Center Bezel Remove/Install
1 - INSTRUMENT PANEL
2 - SCREW (2)
3 - SCREW
4 - CENTER BEZEL
5 - ACCESSORY SWITCH BEZEL
Fig. 3 Radio Remove/Install
1 - MOUNTING SCREWS
(10) If the vehicle is equipped with the CD radio
receiver, go to Step 11. If the vehicle is not equipped
with the CD radio receiver, go to Step 13.
(11) Remove the glove box from the instrument
panel. (Refer to 23 - BODY/INSTRUMENT PANEL/
GLOVE BOX - REMOVAL).
AUDIO 8As - 3