Bearing Retainer; Input Shaft; Front Bearing Retainer Seal; Input And Output Shafts - Jeep Wrangler 2001 Service Manual

21s - 26

MANUAL-AX5

MANUAL-AX5 (Continued)
Adapter 6747-1A
Installer MD-998805

BEARING RETAINER

REMOVAL

(1) Remove release bearing and lever from the
transmission.
(2) Remove the bolts holding the front bearing
retainer to the transmission case.
(3) Remove the front bearing retainer from the
transmission case.
(4) With a pry tool, remove the front bearing
retainer seal.

INSTALLATION

(1) Install new seal in the front bearing retainer
with Tool Handle C-4171 and Installer 8211 (Fig. 81).
(2) Remove any residual gasket material from the
sealing surfaces of the bearing retainer and the
transmission case.
(3) Install new front bearing retainer gasket to the
front bearing retainer.
(4) Install the front bearing retainer onto the
transmission case.
(5) Install the bolts to hold the bearing retainer
onto the transmission case.
(6) Tighten the bolts to 17 N·m (12 ft. lbs.).
(7) Install release bearing and lever onto the
transmission.
2001 JEEP WRANGLER
1 - HANDLE
2 - INSTALLER

INPUT SHAFT

DISASSEMBLY

(1) Verify that the 3-4 synchronizer is in the neu-
tral position.
(2) Separate input shaft from output shaft (Fig.
82). Note that the output shaft pilot bearing is an
uncaged roller type bearing.
1 - INPUT SHAFT ASSEMBLY
2 - OUTPUT SHAFT AND GEAR ASSEMBLY
Fig. 81 Front Bearing Retainer Seal
Fig. 82 Input and Output Shafts
TJ