Sound Bar; Instrument Panel Speaker Bezel Remove/Install; Instrument Panel Speaker Remove/Install; Sound Bar Wire Harness Connector Remove/Install - Jeep Wrangler 2001 Service Manual

TJ
SPEAKER (Continued)
Fig. 5 Instrument Panel Speaker Bezel Remove/
Install
1 - PRY HERE
2 - SPEAKER BEZEL
3 - PRY HERE
4 - MOUNTING SCREWS
Fig. 6 Instrument Panel Speaker Remove/Install
1 - INSTRUMENT PANEL
2 - SPEAKER
3 - SCREW
INSTALLATION
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, (REFER TO
BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL
COMPONENT DIAGNOSIS OR SERVICE. FAILURE
TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
2001 JEEP WRANGLER
ELECTRICAL/RESTRAINTS)
(1) Connect the speaker wire connector to the
speaker.
(2) Position the speaker to the instrument panel.
(3) Install the four speaker retaining screws.
Tighten the screws to 1.1 N·m (10.in.lbs).
(4) Install the speaker bezel to the instrument
panel. Tighten the screws to 2.2 N·m (20 in. lbs.).
(5) Connect the battery negative cable.

SOUND BAR

REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) If the vehicle is equipped with the optional
hard top, remove the hard top from the vehicle.
(Refer to 23 - BODY/REMOVEABLE TOP/TOP -
REMOVAL).
(3) If the vehicle is equipped with the standard
soft top, lower the soft top. Refer to Folding Down
the Fabric Top in the Owner's Manual for the proce-
dures.
(4) Release the hook and loop closure on each out-
board end flap of the sound bar trim cover.
(5) Lift the left outboard end flap of the sound bar
trim cover over the top of the sport bar far enough to
access the wire harness connector (Fig. 7).
Fig. 7 Sound Bar Wire Harness Connector Remove/
Install
1 - SPORT BAR
2 - SOUND BAR
3 - CONNECTOR
AUDIO 8As - 5