Standard Procedure - Fluid And Filter Replacement; Transmission Pan - Typical; Transmission Filter - Typical; Maintenance - Jeep Wrangler 2001 Service Manual

21s - 110 AUTOMATIC - 32RH
FLUID AND FILTER (Continued)
CAUTION: Do not overfill transmission, fluid foam-
ing and shifting problems can result.
(9) Add fluid to bring level up to MAX arrow
mark.
When fluid level is correct, shut engine off, release
park brake, remove funnel, and install dipstick in fill
tube.
STANDARD PROCEDURE - FLUID AND FILTER
REPLACEMENT
For proper service intervals (Refer to LUBRICA-
TION & MAINTENANCE/MAINTENANCE SCHED-
ULES - DESCRIPTION). The service fluid fill after a
filter change is approximately 3.8 liters (4.0 quarts).
(1) Hoist and support vehicle on safety stands.
(2) Remove the transmission/skip plate as neces-
sary to access the transmission oil pan.
(3) Place a large diameter shallow drain pan
beneath the transmission pan.
(4) Remove bolts holding front and sides of pan to
transmission (Fig. 65).
(5) Loosen bolts holding rear of pan to transmis-
sion.
(6) Slowly separate front of pan away from trans-
mission allowing the fluid to drain into drain pan.
(7) Hold up pan and remove remaining bolts hold-
ing pan to transmission.
(8) While holding pan level, lower pan away from
transmission.
(9) Pour remaining fluid in pan into drain pan.
(10) Remove screws holding filter to valve body
(Fig. 66).
(11) Separate filter from valve body and pour fluid
in filter into drain pan.
(12) Dispose used trans fluid and filter properly.
(13) Inspect bottom of pan and magnet for exces-
sive amounts of metal or fiber contamination. A light
coating of clutch or band material on the bottom of
the pan does not indicate a problem unless accompa-
nied by slipping condition or shift lag. If fluid and
pan are contaminated with excessive amounts or
debris, refer to the diagnosis section of this group.
(14) Using a suitable solvent, clean pan and mag-
net.
(15) Using a suitable gasket scraper, clean gasket
material from gasket surface of transmission case
and the gasket flange around the pan.
(16) Place replacement filter in position on valve
body.
(17) Install screws to hold filter to valve body (Fig.
66). Tighten screws to 4 N·m (35 in. lbs.) torque.
(18) Place new gasket in position on pan. and
install pan on transmission.
(19) Place pan in position on transmission.
2001 JEEP WRANGLER
1 - GASKET
2 - PAN
3 - TRANSMISSION
1 - FILTER
2 - TRANSMISSION
(20) Install screws to hold pan to transmission
(Fig. 65). Tighten bolts to 17 N·m (150 in. lbs.)
torque.
(21) Install the transmission/skip plate.
(22) Lower vehicle and fill transmission with
Mopar ATF Plus 4, type 9602 fluid.
Fig. 65 Transmission Pan - Typical
Fig. 66 Transmission Filter - Typical
TJ