Detent Plunger Bushing; Geartrain Assembly; Assembly Fixture; Pilot Bearing And Input Shaft - Jeep Wrangler 2001 Service Manual

21s - 58 MANUAL-NV3550
MANUAL-NV3550 (Continued)
(8) Attach a slide hammer or suitable puller to the
bolt and remove the bearing.
(9) Use the short end of Installer 8119 to install
the new bearing.
(10) The bearing is correctly installed if the bear-
ing is flush with the transmission case.

DETENT PLUNGER BUSHING

Inspect detent plunger bushings for damage and
replace if necessary.
NOTE: The detent plunger bushings are installed to
a specific depth. The space between the two bush-
ings when correctly installed contain an oil feed
hole. Do not attempt to install the bushings with
anything other than the specified tool or this oil
hole may become restricted.
(1) Using the long end of Installer 8119, drive the
detent bushings through the outer case and into the
shift shaft bore.
(2) Remove the bushings from the shift shaft bore.
(3) Install a new detent plunger bushing on the
long end of Installer 8118.
(4) Start the bushing in the detent plunger bore in
the case.
(5) Drive the bushing into the bore until the tool
contacts the transmission case.
(6) Install a new detent plunger bushing on the
short end of Installer 8118.
(7) Start the bushing in the detent plunger bore in
the case.
(8) Drive the bushing into the bore until the tool
contacts the transmission case.

GEARTRAIN ASSEMBLY

(1) Install Adapter 6747-1A on input shaft hub of
Fixture 6747 (Fig. 84).
(2) Install input shaft in fixture tool. Make sure
Adapter 6747-1A is positioned under shaft as shown
(Fig. 85).
(3) Install pilot bearing in input shaft (Fig. 85).
NOTE: The side of the pilot bearing with the small
diameter goes toward the input shaft.
2001 JEEP WRANGLER
1 - SPECIAL TOOL 6747–2B (INSTALL ON COUNTERSHAFT
FRONT HUB)
2 - SPECIAL TOOL 8115
3 - SPECIAL TOOL 6747–1A
4 - SPECIAL TOOL 6747
Fig. 85 PILOT BEARING AND INPUT SHAFT
1 - PILOT BEARING
2 - INPUT SHAFT
Fig. 84 ASSEMBLY FIXTURE
TJ