Table of Contents
Advertisement
6.3
Stapler Faults
This section describes stapling troubles. Follow the procedures on the following pages when
prints are not stapled or when staples are bent. Contact our Customer Support Center if the
problem persists after you have tried the following solutions.
Stapling is available when the professional finisher (optional) and internal hard disk (optional) are installed.
Bent staple
If documents are stapled in the manner shown in the figures below, contact our Customer
Support Center.
One side of staple rising up
Staple bent in reverse direction
6
Flattened staple
Entire staple rising up
Staple rising up with center pressed in
214
Advertisement
Table of Contents
Troubleshooting
