Table of Contents
Advertisement
7.2 Description of Common Menu
■PJL (Note 1) (P.287)
You can use the PJL command with this machine regardless of any print languages used. The PJL
command controls the print job, and is necessary when you use the print driver. Set the status of the
PJL command sent from the computer to enable or disable. By using the PJL command, you can
select any print language for the next data, even if the printer is processing in different print lan-
guage. Set [Enable] for normal use. The default is [Enable].
■Auto Eject Time (Note 1) (P.287)
Set the time to output remaining data in the printer, in case data transmission is interrupted. You can
select from 5 to 1275 seconds, in 5 second increments. The default is [30 Secs]. When the next data
is not received during this time, it is recognized as the end of job.
■Adobe Protocol
Set the communications protocol for PostScript.
[Normal] (default)
Select when the communications protocol is ASCII format.
[Binary]
Select when the communications protocol is Binary format. According to data, the processing speed
of printing in Binary format may be faster than that of [Normal].
[TBCP]
Select when both ASCII format and Binary format is installed in one communications protocol, and
to switch by a specified control code.
Set up accordingly with data format output by the print driver on the computer.
●
Use [Normal] for normal operation.
●
This settings can be used only when it is printed with PostScript.
●
USB-2 (2.0)
Set to use the USB 2.0 port.
The setting items and contents are the same as those of [USB-1 (1.1)].
The default is [Disable]. Set [Enable] when you use the USB port.
7
266
Advertisement
Table of Contents
Troubleshooting
