Fuji Xerox DocuPrint C4350 User Manual page 291

LPD
Set when using LPD.
■Port Startup
Set the status of the LPD port to [Enable] or [Disable] when switching on the power. The default is
[Enable], which allows the use of the LPD port.
To activate the LPD port, need to set the IP address.
When the port is set to [Enable], and if there is insufficient memory, the status of the port may automatically be
reset to [Disable]. Set unused port status to [Disable] or change memory allocation capacity at [Allocate Mem-
ory], in case of insufficient memory.
■Print Mode (Note 1) (P.287)
Set the process method (targeted print language) of the print data.
The optional values are as follows:
[Auto] (default)
Automatically detects which print language is used in data received from the computer, and prints
accordingly with data.
[PS] [ESC/P] [HP-GL/2] [PCL] [TIFF]
Data received from the computer is processed.
■PJL (LOOK 2) (P.287)
With this printer, you can use the [PJL] command regardless of any print languages used. The PJL
command controls the print job, and is necessary when you use the print driver. Set the status of the
PJL command sent from the computer to enable or disable. By using the PJL command, you can
select any print language for the next data, even if the printer is processing different print language.
Set [Enable] for normal use. The default is [Enable].
■Connect Time-out (Note 1) (P.287)
Set up how long it takes to disconnect after data stops being transmitted during data transmission,
within the range from 2 to 3600 seconds with a 1-second interval. The default is [16Secs].
■TBCP Filter
Set the TBCP filter to enable or disable, while data from the PostScript is being processed. The
default is [Disable].
■Port No.
Specify the port number in the range of 8000 to 9999. The default is [515].
7.2 Description of Common Menu
7
261