Fuji Xerox DocuPrint C4350 User Manual page 276

6.5 List of Messages
Error code
027-797
116-701
116-702
116-703
116-710
116-711
116-712
6
116-714
116-715
116-718
116-737
246
[Cause] Destination e-mail address is illegal.
[Action] Specify the correct address, and send the e-mail again.
"4.13 Sending a Document to the Printer by E-Mail (E-mail Print-
ing)"(P.90)
[Cause] 2 sided print cannot be done, as memory is insufficient.
[Action] It is recommended to increase memory capacity.
[Cause] Alternative font is used for printing.
[Action] Check the print data.
[Cause] An error occurred in PostScript.
[Action] [Action] Check the print data or set bidirectional communication
to off using spool setting of [Advanced] tab of the print driver.
[Cause] It is possible that document size judgment is incorrect, as receive
data exceeds the HP-GL, HP-GL/2 spool size.
[Action] It is recommended to increase the allocated HP-GL or HPGL/2
auto layout memory or install the extension hard disc.
[Cause] The specified size and orientation of PCL form do not match the
print paper.
[Action] Correct the paper size and orientation according to specified PCL
form and then retry.
[Cause] The form cannot be registered, as PCL form memory is insuffi-
cient.
[Action] Delete unnecessary forms and increase the PCL form memory
capacity.
[Cause] An HP-GL or HP-GL/2 command error occurred.
[Action] Check the print data.
[Cause] The form cannot be registered, as the upper limit of PCL form
registration has reached.
[Action] Delete unnecessary forms.
[Cause] The specified PCL form is not registered yet.
[Action] Use an already registered form or newly register the form. The
form registration status can be checked using [PCL Forms List].
"5.6 Printing Report/List"(P.152)
[Cause] User definition data cannot be registered, as PCL user definition
memory is insufficient.
[Action] Delete unnecessary data or increase the PCL user definition
memory capacity.
Cause/action