Table of Contents
Advertisement
Message
Ready to print
(***-***)
Ready to print DNS Update
Fail
Ready to print Get IP Add.
Fail
Ready to print Dupl. IP
Address
Ready to print Dupl. SMB
host
Print Ready-CallService ***-
***
Ready to print Replace ***-
***
Ready to print Add Toner: C
[Cause]
Failure occurs in the printer.
[Action]
Switch off the printer, and make sure that control panel dis-
play goes off. Then switch it back on. If this message
appears again, check error code [***-***] on the display. And
take an appropriate action.
"6.5.2 List of Error Codes" (P.237)
[Cause]
The IP address cannot be obtained from DNS.
[Action]
Set the IP address manually.
"1.3 Setting the IP Address" (P.9)
[Cause]
Obtaining the IP address from the DHCP server failed.
[Action]
Set the IP address manually.
"1.3 Setting the IP Address" (P.9)
[Cause]
The IP address is already in use.
[Action]
Change the IP address.
"1.3 Setting the IP Address" (P.9)
[Cause]
The same SMB host name already exists.
[Action]
Change the host name.
Manual contained on Software Pack CD-ROM.
[Cause]
Some parts need to be replaced.
[Action]
Inform our Customer Support Center or your dealer of [***-
***] indicated on the control panel display.
[Cause]
Some parts need to be replaced soon.
[Action]
Inform our Customer Support Center or your dealer of [***-
***] indicated on the control panel display.
[Cause]
Toner in the cyan toner cartridge is about to run out.
[Action]
Prepare a new cyan toner cartridge.
"5.5.2 Replacing Toner Cartridges" (P.135)
Print processing and receiving print data from the computer are possible.
6.5 List of Messages
Cause/action
6
233
Advertisement
Table of Contents
Troubleshooting
