Table of Contents
Advertisement
7.2 Description of Common Menu
■PJL (LOOK 2) (P.287)
You can use the PJL command with this printer regardless of any print languages used. The PJL
command controls the print job, and is necessary when you use the print driver. Set the status of the
PJL command sent from the computer to enable or disable. By using the PJL command, you can
select any print language for the next data, even if the printer is processing using different print lan-
guage. Set [Enable] for normal use. The default is [Enable].
■Adobe Protocol
Set the communications protocol for PostScript.
The optional values are as follows:
[Normal] (default)
Select when the communications protocol is ASCII format.
[Binary]
Select when the communications protocol is Binary format. The processing of printing in Binary for-
mat may be faster than that of [Normal] depending on the type of data.
[TBCP]
Select when both ASCII format and Binary format are used in the communications protocol, and to
switch over by a specified control code.
Set up accordingly with data format output by the print driver on the computer.
●
Use [Normal] for normal operation.
●
These settings can be used only when the parallel print mode is [PS].
●
■Auto Eject Time (Note 1) (P.287)
Set the time to output the remaining data in the printer, in case data transmission is interrupted.
You can select from 5 to 1275 seconds, within 5-second interval. The default is [30 Secs]. When the
next data is not received during this time, it is recognized as the end of the job.
■Bi-directional
Enable or disable bi-directional communications (IEEE1284) for the parallel interface. The default is
[Enable].
7
260
Advertisement
Table of Contents
Troubleshooting
