Table of Contents
Advertisement
Port9100
Set when using Port9100.
■Port Startup
Set the status of the Port9100 port to enable or disable when the power is switched on. The default is
[Disable]. Set [Enable] when you use Port9100.
To activate the port9100 port, need to set the IP address.
If memory becomes insufficient when the port is set to [Enable], the status of the port may be automatically set
to [Disable]. Set the status of the unused port to [Disable], or change memory allocation capacity at [Allocate
Memory], in case of insufficient memory.
■Print Mode (LOOK 1) (P.287)
Set the process method (targeted print language) of the print data.
The optional values are as follows:
[Auto] (default)
Automatically detects which print language is used in data received from the computer, and prints
accordingly with data.
[PS] [ESC/P] [HP-GL/2] [PCL] [TIFF]
Data received from the computer is processed.
■PJL (LOOK 2) (P.287)
You can use the PJL command with this printer regardless of any print languages used. The PJL
command controls the print job, and is necessary when you use the print driver. Set the status of the
PJL command sent from the computer to enable or disable. By using the PJL command, you can
select any print language for the next data, even if the machine is processing in different print lan-
guage. Set [Enable] for normal use. The default is [Enable].
■Connect Time-Out (Note 1) (P.287)
Set up how long it takes to disconnect after data stops being transmitted while receiving print data in
the range of 2 to 65535 seconds with a 1-second interval. The default is [60 Secs].
■Port No.
Set the port number in the range of 1 to 65535. The default is [9100].
■TBCP Filter
Set the TBCP filter to enable or disable, while data from the PostScript is being processed. The
default is [Disable].
UPnP
Set when using Universal Plug and Play (UPnP).
■Port Startup
Set the status of the UPnP port to enable or disable when the power is switched on. The default is
[Disable]. Set [Enable] when you use UPnP.
If memory becomes insufficient when the port is set to [Enable], the status of the port may be automatically set
to [Disable]. Set the status of the unused port to [Disable], or change memory allocation capacity at [Allocate
Memory], in case of insufficient memory.
■Port No.
Select the port number in the range of 1 to 65535. The default is [80].
7.2 Description of Common Menu
7
267
Advertisement
Table of Contents
Troubleshooting
