Assigning An Ip Address Using Http; Figure 3-1: Enter Network Password Screen - AudioCodes Mediant 1000 MSBG Installation And Configuration Manual
Enhanced media gateway and sba for microsoft lync
Hide thumbs
Also See for Mediant 1000 MSBG:
- Configuration note (60 pages) ,
- Release notes (178 pages) ,
- Cli reference manual (160 pages)
Table of Contents
Advertisement
3.1.1.1
Assigning an IP Address using HTTP
You can assign an IP address to the device, using the device's Web interface.
To assign an IP address using HTTP:
1.
Disconnect the device from the network and reconnect it to a PC using one of the following
methods:
•
Using a hub or switch between a PC and the device: Connect the network interface
on your PC to a port on a network hub / switch, using a standard Ethernet cable.
Connect the device to another port on the same network hub / switch, using another
standard Ethernet cable.
•
Direct connection between a PC and the device: Connect the network interface on
your PC directly to the device, using an Ethernet crossover cable.
2.
Change your PC's IP address and subnet mask to correspond with the device's factory
default IP address and subnet mask.
3.
Access the device's Web interface:
a.
Open a standard Web browser application and in the Uniform Resource Locator (URL)
field, enter the device's default IP address (e.g., http://10.1.10.10); the Web interface's
'Enter Network Password' dialog box appears, as shown in the figure below:
b.
Enter the device's default login, case-sensitive user name ('Admin') and password
('Admin'), and then click OK; the Web interface is accessed, displaying the Web
interface's 'Home' page.
4.
Change the device's IP address, by performing the following:
a.
Open the 'Multiple Interface Table' page, (Configuration tab > Network Settings menu
> IP Settings).
b.
Define the device's IP address, subnet mask, and default Gateway IP address (for
"OAMP + Media + Control" application type) so that they correspond to your network IP
scheme.
c.
Click Apply.
d.
Save your settings to the flash memory and reset the device.
5.
Disconnect your PC from the device or from the hub/switch (depending on the connection
method used in Step 1).
6.
Reconnect the device and PC (if necessary) to the network.
7.
Restore your PC's IP address and subnet mask to their original settings. If necessary, restart
your PC and re-access the device via the Web interface with its newly assigned IP address.
AudioCodes Enhanced Media Gateway
Figure 3-1: Enter Network Password Screen
38
Survivable Branch Appliance
Document #: LTRT-18206
Advertisement
Table of Contents
