Assigning An Ip Address Using The Cli; Figure 3-1: Client Configuration Screen With Blank Parameters - AudioCodes Mediant 2000 Installation Manual

In the 'Subnet' field, enter the subnet mask you want to assign the gateway. Use the normal
8.
dotted decimal format. Ensure that the subnet mask is correct. If the address is incorrect, the
gateway may not function until the entry is corrected and a BootP reset is applied.
In the 'Gateway' field, enter the IP address for the default gateway. If you do not know the IP
9.
address for the default gateway, contact your network administrator.
Click Apply to save this entry to the list of clients.
10.
Click OK; the 'Client Configuration' screen is closed.
11.
Use the reset button (located on the Mediant 2000 front panel) to physically reset the
12.
gateway causing it to use BootP; the Mediant 2000 changes its network parameters to the
values provided by the BootP.
Repeat steps 2 to 11 for the Mediant 2000 second module (if used).
13.

Figure 3-1: Client Configuration Screen with Blank Parameters

3.1.3

Assigning an IP Address Using the CLI

To assign an IP address using the CLI, take these 7 steps:
Enable the Embedded Telnet Server:
1.
Access the Mediant 2000 Embedded Web Server (refer to Section
Set the parameter 'Embedded Telnet Server' (under Advanced Configuration >
Network Settings > Application Settings) to 'Enable (Unsecured)'.
Click the Reset button on the main menu bar; the Reset screen is displayed.
Click the Reset button in the middle of the Reset screen with the Burn option selected;
the Mediant 2000 is shut down and re-activated. A message about the waiting period is
displayed. The screen is refreshed.
Use a standard Telnet application to connect to the Mediant 2000 Embedded Telnet Server.
2.
Login using the username ('Admin') and password ('Admin').
3.
At the prompt type 'conf' and press enter; the configuration folder is accessed.
4.
Mediant 2000 18
Mediant 2000
3.3 on page 19).
Document #: LTRT-70105