Configuring Virtual Links - Dell PowerConnect 8024 User Configuration Manual

Configuring Virtual Links

Beginning in Privileged EXEC mode, use the following commands to
configure OSPFv3 Virtual Links.
Command
configure
ipv6 router ospf
area-id
area virtual-link
neighbor-id
area-id
area virtual-link
neighbor-id
retransmit-
seconds
interval
area-id
area virtual-link
neighbor-id
hello-interval
seconds
area-id
area virtual-link
neighbor-id
dead-interval
seconds
area-id
area virtual-link
neighbor-id
transmit-
seconds
delay
exit
exit
show ipv6 ospf virtual-
link brief
Purpose
Enter global configuration mode.
Enter OSPFv3 configuration mode.
Create the OSPFv3 virtual interface for the specified
area-id
and neighbor router. The
the IP address of the neighboring router.
Set the OSPFv3 retransmit interval for the virtual link
interface.
seconds
The variable is the number of seconds to wait
between retransmitting LSAs if no acknowledgement is
received. (Range: 0–3600)
Set the OSPFv3 hello interval for the virtual link.
seconds
The variable indicates the number of seconds to
wait before sending Hello packets from the virtual
interface. (Range: 1–65535).
Set the OSPFv3 dead interval for the virtual link.
seconds
The variable indicates the number of seconds to
wait before the virtual interface is assumed to be dead.
(Range: 1–65535)
Set the OSPFv3 Transit Delay for the interface.
seconds
The variable is the number of seconds to
increment the age of the LSA before sending, based on
the estimated time it takes to transmit from the
interface. (Range: 0–3600)
Exit to Global Config mode.
Exit to Privileged EXEC mode.
View summary information about all virtual links
configured on the switch.
Configuring OSPF and OSPFv3
neighbor-id
variable is
993