Configuring The Dhcpv6 Server And Relay (Cli); Configuring Global Dhcp Server And Relay Agent Settings; Configuring A Dhcpv6 Pool For Stateless Server Support - Dell PowerConnect 8024 User Configuration Manual

Configuring the DHCPv6 Server and Relay (CLI)

This section provides information about the commands you use to configure
and monitor the DHCP server and address pools. For more information about
the commands, see the
CLI Reference Guide

Configuring Global DHCP Server and Relay Agent Settings

Beginning in Privileged EXEC mode, use the following commands to
configure settings for the DHCPv6 server.
Command
configure
service dhcpv6
ipv6 dhcp relay-agent-
option
info-opt
ipv6 dhcp relay-agent-
info-remote-id-subopt
suboption
exit
show ipv6 dhcp

Configuring a DHCPv6 Pool for Stateless Server Support

Beginning in Privileged EXEC mode, use the following commands to create a
pool and configure pool parameters for DHCPv6 clients that obtain IPv6
network information dynamically.
Command
configure
name
ipv6 dhcp pool
ipv6-address
dns-server
PowerConnect 8024/8024F/8132/8132F/8164/8164F
at support.dell.com/manuals.
Purpose
Enter Global Configuration mode.
Enable the DHCPv6 server.
Configure a number to represent the DHCPv6 Relay
Agent Information Option.
option
The parameter is an integer from 54–65535.
Configure a number to represent the DHCPv6 remote-ID
sub-option
suboption
The parameter is an integer from 1–65535.
Exit to Privileged EXEC mode.
Verify the global DHCPv6 server configuration.
Purpose
Enter Global Configuration mode.
Create a DHCPv6 pool and enter DHCPv6 pool
configuration mode.
Set up to 8 IPv6 DNS server addresses to provide to a
DHCPv6 client by the DHCPv6 server.
Configuring DHCPv6 Server and Relay Settings
1095