Configuring Rip Interface Settings - Dell PowerConnect 8024 User Configuration Manual

Configuring RIP Interface Settings

Beginning in Privileged EXEC mode, use the following commands to
configure per-interface RIP settings.
Command
configure
vlan-id
interface vlan
ip rip
ip rip send version {rip1
rip1c | rip2 |none}
ip rip receive version
{rip1 | rip2 | both |
none}
ip rip authentication
{none | {simple
key key-id
{encrypt
exit
exit
show ip rip interface vlan
vlan-id
show ip rip interface
brief
1028
Configuring RIP
Purpose
Enter global configuration mode.
Enter Interface Configuration mode for the specified
VLAN.
Enable RIP on the interface.
Configure the interface to allow RIP control packets of the
specified version(s) to be sent.
Configure the interface to allow RIP control packets of the
specified version(s) to be received.
set the RIP Version 2 Authentication Type and Key for the
key
} | interface.
}
key
• — Authentication key for the specified interface.
(Range: 16 bytes or less)
• encrypt — Specifies the Ethernet unit/port of the
interface to view information.
key-id
•
authentication type encrypt. (Range: 0-255)
Exit to Global Configuration Mode
Exit to Privileged Exec mode.
View RIP configuration information for the specified
routing interface.
View summary information about the RIP configuration
on all interfaces.
— Authentication key identifier for