Configuring And Viewing Ipv6 Multicast Route Information - Dell PowerConnect 8024 User Configuration Manual

Configuring and Viewing IPv6 Multicast Route Information

Beginning in Privileged EXEC mode, use the following commands to
configure static IPv6 multicast routes on the switch and to view IPv6
multicast table information.
Command
configure
source-
ipv6 mroute
address/prefix-length rpf-
address preference
exit
show ip mcast interface
vlan-id
[vlan ]
show ipv6 mroute
{detail | summary}
show ipv6 mroute group
groupipaddr
{detail |
summary}
show ipv6 mroute source
sourceipaddr
{summary
groupipaddr
| }
show ipv6 mroute static
sourceipaddr
[ ]
Purpose
Enter global configuration mode.
Create a static multicast route for a source range.
source-address/prefix-length
•
multicast data source.
rpf-address
• — The IPv6 address of the next hop towards
the source.
preference
• — The cost of the route (Range: 1 - 255).
Exit to Privileged EXEC mode.
View the multicast information for all interfaces or for the
specified interface.
View a summary or all the details of the multicast table.
View the multicast configuration settings such as flags,
timer settings, incoming and outgoing interfaces, RPF
neighboring routers, and expiration times of all the entries
in the multicast mroute table containing the
value.
View the multicast configuration settings such as flags,
timer settings, incoming and outgoing interfaces, RPF
neighboring routers, and expiration times of all the entries
in the multicast mroute table containing the
sourceipaddr groupipaddr
or |
View all the static routes configured in the static mcast
table if it is specified or display the static route associated
with the particular
Managing IPv4 and IPv6 Multicast
— The IPv6 address of the
pair value(s).
sourceipaddr
.
groupipaddr
sourceipaddr
1217