Subapplication Check Slope - Leica FlexLine TS02 User Manual

9.13.7
Description

Access
Applications

Subapplication Check Slope

The subapplication Check Slope is used for as-built checks and to get information
about slopes, for example on a natural surface. If the parameter offset left/right and
height difference are not entered, the point on the horizontal alignment is the hinge
point.
h
a
b
d
j
f
TSOX_055
Defined chainage and increment values will not be considered in the subapplication
Check.
Press CH-SLP from the Define Stake/Check/Slope values screen.
P1
a
g
b
c
c
d
e
i
e
P1
f
g
h
i
j
Measured point
Horizontal alignment
Defined offset
Defined height difference
Hinge point
Actual slope
Natural surface
Offset to hinge point
Offset to alignment
Height difference to hinge point
Height difference to alignment
FlexLine, 197