Application Programs - Getting Started; Starting An Application Program - Leica TM30 Series Field Manual

1

Application Programs - Getting Started

1.1

Starting an Application Program

Access
an application
program
step-by-step
XX Begin
Application Programs - Getting
Started
Step Description
1. PROG. The PROG key opens the TPS1200+ Programs menu.
2. Select an application program from the menu.
3. Press CONT (F1) to access a Begin screen.
Some application programs are protected. They are activated through a
specific licence key. This can either be typed in Main Menu:
Tools...\Licence Keys or the first time the application program is started.
Four application programs can be open at one time. XX Begin is shown
for the application program opened first, but not for the following applica-
tion programs.
SURVEY Survey Begin is shown as an example. Additional fields are available for
particular application programs.
Description of fields
Field Option
<Stakeout Job:> Choicelist
<Fixpoint Job:> Choicelist
TPS1200+/TS30/TM30
CONT (F1)
To accept changes and access the
subsequent screen.
CONF (F2)
To configure the application program.
SETUP (F3)
To set up the station.
CSYS (F6)
To select a different coordinate
system. Not available for <Use Auto
CrdSys: Yes> configured in CONG-
FIGURE Additional Rover
Settings.
Description
• Available for Stakeout.
• The job containing the points to be
staked.
• Available for Traverse.
• The job containing points for the
control points, to begin, to check and
to end the traverse.
7