Front Brake Lever Adjustment And Fluid Level Check; Clutch Control; Position Adjustment - Husqvarna TR 650 TERRA 2013 Workshop Manual

2
MIN
1
1
Workshop Manual Ed. 09-2012
SETTINGS AND ADJUSTMENTS
TR 650 TERRA 2013 - TR 650 STRADA 2013

Front brake lever adjustment and fluid level check

The level of the fluid in the master cylinder reservoir must never be below the
minimum level visible through the inspection sight glass (1) on the side of the
master cylinder (2) body.
A decrease of the fuel level will let air into the sustem, hence an extension of
the level stroke.
H11671

Clutch control

The clutch control lever (1) is located on the left-hand side of the handlebar.

Position adjustment

The position of the clutch control on the handlebar can be adjusted by loosening
the retaining screws (2).
2
H11672
A "STOP" switch on the clutch lever support allows you to start the engine when
the motorcycle is in gear or the clutch lever is pulled (the stand must be off the
ground).
If the brake lever feels mushy when pulled, there may be air in the
brake line or the brake may be defective: CHECK THE BRAKING
SYSTEM (see Section "L").
Too much brake lever free play may reduce braking action: CHECK
BRAKE PAD THICKNESS (see Section "L").
Do not spill brake fluid onto any painted surface or lens (for example
lights lens).
Do not mix two brands of fluid. Completely change the brake fluid
in the brake system if you wish to switch to another fluid brand.
Brake fluid may cause irritation. Avoid contact with skin or eyes. In
case of contact, flush thoroughly with water and call a doctor if your
eyes were exposed.
After adjustment, turn the handlebar as far as possible to the left
and make sure that the lever does not touch the bodywork.
Do not forget to tighten the screws (2) after adjusting.
D.6