Friction Plate To Clutch Housing Clearance; Clutch Spring - Husqvarna TE 250 - 310 2011 I.E. Workshop Manual

Ed. 07-2010
ENGINE OVERHAUL

Friction plate to clutch housing clearance

Measure clearance "A" between clutch housing (2) and plate (1) with a feeler
gauge and compare measured clearance with the table below.
If measured clearance exceeds the service limit, replace clutch
plates or housing and repeat measurement. If measurement is still
outside the service limit, replace the complete clutch assembly.

Clutch spring

Measure the free length "L" of each spring with a calliper.
New spring L= 37.3 mm (1.4685 in.).
Service limit: 35 mm (1.3779 in.).
Change any spring that is outside the service limit.
G.17
STANDARD
0.30-0.50 mm
(0.012-0.020 in.)
SERVICE LIMIT
0.6 mm
(0.024 in.)