Disassembly And Replacement - Toshiba e-studio550 Service Manual

13. 4. Disassembly and Replacement

[A] Transfer belt unit
(1) Open the front cover, turn the handle clockwise
and pull out the transfer/transport unit.
(2) Remove 1 screw and take off the hundle.
(3) Remove 2 screws and take off the cover.
(4) Disconnect 2 connectors, remove 1 clip and take
off the front side bearing. Then remove 4 screws
and take off the transfer belt unit.
Note: When installing the transfer belt unit, install it as
the lever comes under the cam.
e-STUDIO550/650/810 TRANSFER/TRANSPORT UNIT
Clip
13 - 4
Connector
Cam
JUNE 2002 © TOSHIBA TEC
Lever