Toshiba e-studio550 Service Manual page 267

(7) Back side registering to set the top side
Same operation as 16.5.2.(6)
(8) Start of top side feeding
Same operation as 16.5.2.(7)
(9) Start of scanning
Scanning begins after receiving the original transport signal from the copier, and at the same time, the
original stop signal is reset. The read motor starts to rotate foward and so does the large original exit
motor. Then the disengagement solenoid turns ON. (The large original exit solenoid has been ON since
the original was idle reversed.)
The SCN-STR turns ON when the leading edge of the original has reached the scanning section.
When the leading edge of the original is transported to the large original exit and reaches the 3rd roller,
the large original exit motor starts to rotate in reverse.
When the trailing edge of the original has passed the scanning section, the SCN-STR turns OFF, and at
the same time, both the read and large original exit motors start to accelerate. Then the
disengaEgement solenoid turns OFF.
With a next original, feeding of the original begins when the trailing edge of the original has passed the
4th roller.
e-STUDIO550/650/810 RADF 16 - 30 JUNE 2002 © TOSHIBA TEC