Toshiba e-studio550 Service Manual page 143

[D] Tray drive unit
(1) Remove the rear cover and take off the power
supply unit.
(2) Remove 4 screws and take off the tray drive
unit.
(3) Turn over the tray drive unit. Then release 6
latches and take off the cover.
Note: Since the spring inside the tray drive unit is
forcing the cover to extend, be careful when taking
off the cover.
(4) Remove the tray-up motor.
Note: Make sure the bosses of the gear fit into the
hole of the cover when installing the unit.
[E] Feed motor
(1) Remove the rear cover.
(2) Disconnect 1 connector, remove 2 screws and
take off the feed motor.
e-STUDIO550/650/810 PAPER FEEDING SYSTEM
Latch
Boss
9 - 20
Latch
Tray-up motor
JUNE 2002 © TOSHIBA TEC