Toshiba e-studio550 Service Manual page 314

(E-2) Tray lift motor
(1) Remove the ADF rear cover.
(2) Remove the ADF board with the bracket.
(3) Remove 2 screws and take off the tray lift
motor with the bracket.
(4) Pull out 2 pullies from the shaft and release
the tray lift motor from the bracket.
(E-3) Read motor
(1) Remove the ADF rear cover.
(2) Remove the tension spring.
(3) Disconnect 1 connector.
(4) Remove 2 screws and take off the read motor
with the bracket.
(5) Remove 2 screws and release the read motor
from the bracket.
<Installing procedure>
(6) Install the read motor to the bracket. While
hunging the timing belt around both pullies
at the RADF unit and read motor, move the
bracket downward and tack it there
temporarily with 2 screws.
(7) Hook the tension spring on the brackets.
(8) Loosen the screws temporarily, and tighten
them up while stretching the timing belt.
Note: Make sure that the timing belt is not moved to
the edges.
JUNE 2002 © TOSHIBA TEC
Tray lift motor
Read motor
Tension spring
16 - 77 e-STUDIO550/650/810 RADF