Disassembly And Replacement - Toshiba DP1600 Service Manual

7.9 Disassembly and Replacement

[A] Scanner assembly
1. If an Original Cover (KA-1600PC), ADF
(MR-2012), or the RADF (MR-3011) is attached
to the copier, detach it.
2. If a STP (KK-1600) is attached to the copier,
detach it.
3. Detach the manual pocket.
4. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate.
5. Detach rear cover. (See Fig. 2-6-1)
6. Detach top cover. (See Fig. 2-6-2)
7. Detach scanner cover.
(See Fig. 2-6-3 and 2-6-4)
8. Detach top cover L. (See Fig. 2-6-5)
9. Detach top cover R. (See Fig. 2-6-6)
10. Detach control panel front cover.
(See Fig. 2-6-7)
11. Detach control panel bottom cover.
(See Fig. 2-6-8)
12 If a FAX kit (GD-1600-NA/TW/EU/AU) is at-
tached to the copier, detach the FAX PWB and
NCU PWB.
13. If a PCL kit (GA-1030/GA-1031) is attached to
the copier, detach it.
14. If a NIC kit (GF-1110) or I-FAX (GD-1070) is at-
tached to the copier, unplug the connectors for
CN14 and CN17.
15. If finisher (MJ-1011) is attached to the copier,
detach the finisher PWA.
16. Remove MAIN PWA.
(See Fig. 2-6-25 and 2-6-25-1)
17. Remove the one screw to release the washer
and clamp.
18. Detach one connector from RELAY PWA
(CN49) and release 2 clamps.
19. If the damp heater is installed, remove the screw
and detach FUS PWA cover. (See Fig. 2-6-33)
20. If the damp heater is installed, detach the damp
heater harness connector and release the three
clamps.
1600/2000/2500 SCANNER
Washer
Clamp
Screw
CN49
RELAY PWA
FUS PWA
7 - 18
Clamp
Fig. 7-8-1
Clamp
CN111
Fig. 7-8-2
December 2000 © TOSHIBA TEC
039-1
039-3