Toshiba e-studio550 Service Manual page 159

(3) Disconnect 1 connector, remove 2 screws and
take off the wire cleaner drive motor with the
bracket.
(4) Remove 2 screws and take off the motor.
(5) Disconnect 2 connectors, remove 1 screw and
take off the wire cleaner stop position switch.
Note: When installing the switch, fix it with pushing it
toward the arrow
color of the harness when connecting the
connectors to the terminals, and then bend the
terminals 45 degrees.
[C] Discharge lamp
(1) Remove the main charger and cleaner unit.
(2) Disconnect 1 connector, remove 1 screw
and take off the discharge lamp.
[D] Ozone filter
(1) Remove 1 screw and pull out the ozone filter
at the exit side.
e-STUDIO550/650/810 PROCESS RELATED SECTION
. Also, pay attention to the
Black
Purple
Connector
10 - 10
Wire cleaner drive motor
45
Connector
A
JUNE 2002 © TOSHIBA TEC