Toshiba e-studio550 Service Manual page 61

4. 2. 4. Bypass copying
(1) Paper inserted into bypass feed tray.
•
SFB feed sensor turned ON
~ "READY FOR BYPASS FEEDING" displayed
(2) [START] key pressed
•
"READY FOR BYPASS FEEDING" display changed to "COPYING"
•
Main charger, developer bias and discharge lamp turned ON/Each fan rotating at a high speed
•
Drum, developer unit, transfer belt, and fuser roller rotating
(3) Sheet-bypass feeding
•
Bypass pickup solenoid turned ON and feed motor rotating in reverse
~ Bypass pickup roller lowered
•
Bypass feed clutch turned ON
~ Bypass feed roller, paper feed roller, and separation roller rotating
•
Aligning operation
•
Paper reaching registration roller
•
Bypass pickup solenoid, feed motor and bypass feed clutch turned OFF in a certain period of
time later
(4) Same operations as (3) through (6) of cassette feed copying with [START] key ON carried out
4. 2. 5. Interrupt copying
(1) [INTERRUPT] key pressed
• Interruption lamp turned ON
• Copying operation temporarily halted and carriages-1 and -2 returning to their home position
• "JOB INTERRUPTED JOB 1 SAVED" displayed
• Copying mode set to automatic density and 1-to-1 reproduction ratio and copy quantity indicator
unchanged
(2) Preferred copying modes specified
(3) After an interrupt copying is terminated:
• "PRESS INTERRUPT TO RESUME JOB 1" displayed
• Interruption lamp turned OFF/Copier returning to conditions before interruption when [INTERRUPT]
key is pressed again
• "READY TO RESUME JOB 1" displayed
(4) [START] key pressed
• Back to copying operation before interruption
JUNE 2002 © TOSHIBA TEC 4 - 5 e-STUDIO550/650/810 GENERAL OPERATION