Toshiba e-studio550 Service Manual page 148

(G-7) End fence stop position sensor
(1) Disconnect 1 connector, remove 1 screw and
release the bracket.
(2) Release the latches and take off the sensor.
Note: Remember that the position where the end fence
stop position sensor is installed depends on a
paper size.
(G-8) End fence motor
(1) Disconnect 1 connector.
(2) Remove 3 screws, and take off the end fence
motor.
JUNE 2002 © TOSHIBA TEC
[A4 size]
End fence stop position sensor
Bracket
Connector
9 - 25 e-STUDIO550/650/810 PAPER FEEDING SYSTEM
[LT size]
Feed side
Standby
side
End fence motor