Toshiba e-studio550 Service Manual page 235
Digital plain paper copier
Hide thumbs
Also See for e-studio550:
- Operator's manual (179 pages) ,
- Service handbook (314 pages) ,
- Operator's manual (148 pages)
Table of Contents
Advertisement
[C] Sensor
(1) Disconnect 1 connector, remove 2 screws (1 for
the lower sensor) and take off the sensors.
[D] Gate solenoid
(1) Disconnect 1 connector, remove 2 screws and
take off the solenoid.
Note: When installing the solenoid, put together both
edges of the plate and solenoid.
While the solenoid is ordinarily screwed up at
the A position, it can be slided if screwed up at
the B position.
[E] Reverse motor
(1) Remove the reverse section drive unit.
(2) Disconnect 1 connector, remove 6 screws and
take off the transport guide.
(3) Disconnect 1 connector, remove 2 screws and
take off the reverse motor.
JUNE 2002 © TOSHIBA TEC
A
B
Connector
Connector
15 - 7
e-STUDIO550/650/810 EXIT/REVERSE SECTION
- Quick Links:
- Specifications
- Table of Contents
- Drum
Hide quick links:
Advertisement
Chapters
Table of Contents
